SimpliServDocs

Configure working time rules

Set break model, real-time notices, time clock rounding and surcharges for working time valuation

→ Open working time rules · Open time reports

Under Administration → Staff & time → Working time rules you define how SimpliServ checks and values working time. For Austria everything is prefilled appropriately. The rules affect the notices when stamping, the working time compliance and the valuation in the time report – they never change the original stamp.

The settings are a business and legal basis. Check them with your payroll or labour law advisors, especially with deviating agreements and several countries.

The page requires the permission work_time_rules.manage. If there are rule sets for several countries, first choose the Country at the top. Each card has its own save button.

Set the break model

Check the country

Choose the rule set for the team's country.

Choose the break model

In the Break rules card under Break model: One break of 30 minutes (default), Two breaks of 15 minutes, Three breaks of 10 minutes or One 15-minute break.

Document the agreement

If the break is split, enter in the Agreement note where this is regulated (e.g. works agreement). Then save.

After six hours of work a break is mandatory. Only use a split model if the agreement really exists. Whether the mandatory break starts automatically is set in the time clock.

Real-time notices

In the Real-time notices card you activate Show notices when clocking. Staff then immediately see a notice when stamping, e.g. for too short a rest period, a missing break or exceeded maximum working time. The entry is saved anyway – a control signal, not a block.

Time clock rounding

Rounding doesn't change the stored stamp, only the valued working time. In the Time clock rounding card:

  • switch on Round clock-in.
  • choose the Start grid: every 5, 10, 15 or 30 minutes.
  • enter the Grace in minutes: anyone stamping within these minutes starts at the previous mark, anyone later only at the next. The tolerance must be smaller than the interval.
  • optionally Grace when leaving: full blocks are paid; anyone clocking out this many minutes before the next mark still gets the block. 0 = clock-out isn't rounded.

Example with a 15-minute interval and 5 minutes tolerance: stamp at 08:04 → start of work 08:00, stamp at 08:06 → start of work 08:15. The card shows the effect of your values directly as an example.

Explain rounding to the team. The visible stamp and the valued time can deliberately differ. Check a test day in the time report before using the rule in production.

Surcharges and night window

In the Surcharges card you maintain:

FieldDefault / note
Overtime surchargestatutory 50 %
Increased overtime surchargefor night, Sundays and holidays, usually 100 %
Night windowdefault 22:00 to 06:00
Increased surcharge for night work, Increased surcharge on Sundays, Increased surcharge on public holidaysovertime in these times gets the increased surcharge
Part-time extra hours surchargestatutory 25 %
Part-time compensation windowstatutory 3 months of surcharge-free compensation
Time-off factorusually 1.5 hours of time off in lieu per overtime hour

These rates flow into the valuation columns of the time report.

Save and check

After saving each card a confirmation appears. Then check:

  1. a test booking before, in and after the night window,
  2. a case with a split break,
  3. a stamp near the rounding boundary,
  4. a Sunday or public holiday,
  5. the display in the time report.

Don't change rules retroactively as a substitute for correcting individual bookings. Record from which period a new rule should apply.

How is this guide?

On this page